欧利臻原保养木油 - OLI-NATURA Wood Care Oil

欧利臻原保养木油是用于涂油的家具、楼梯、木制品、拼花及软木地板的保养和修复。

以亚麻籽油为基础的保养油，适合所有木和软木地板，楼梯和家具表面保养和维护。
使经受表面表面污染的木材，再次延长使用寿命。
显现木材的纹理和自然颜色。
用量:1升可以涂50-100平方米。
环保，提供一个健康的室内环境，没有防腐剂或芳香剂，适合在玩具上使用。

产品

欧利臻原保养木油是用于涂油的家具、楼梯、木制品、拼花及软木地板的保养和修复而研发的。同样适合工厂出品的涂油表面(做初步测试)。具有保养和修复双重功能，可以修复木头较小的表面缺陷，并使木头恢复色彩和光泽。具有防静电、表面有效抗污和防水。它可以应用于整个表面以及部分，自然色的保养木油适用于无色的涂油表面，白色的保养木油适用于白色的涂油表面，该产品不含杀虫剂和防腐剂。完全固化的材料对人植物和动物无害。符合DIN 53160耐唾液和防汗测试和符合DIN EN 71 - 3标准(玩具安全标准)。

了解更多

联系我们
检测标准
操作说明

光泽度:

自然/无色 A01395，白色 A01396

包装规格:

1 升，250毫升

用量:

取决于基材的应用面积和吸收率，10 - 20 g / m²(50 - 100 m²/ l)

工具:

不起毛的棉布料,喷雾器,白色垫

DIN EN 71-3（玩具安全标准）
DIN 53160（唾液和防汗标准）
Free of formaldehyde and aromatic compounds 无游离甲醛和芳香族化合物
Without biocidal substances and preservatives 不含杀虫剂和防腐剂

表面必须干燥，干净，无灰尘和油脂。在地板上：通过清扫或吸尘清除的污垢。然后，如有必要，请根据制造商的指导适用欧利臻原油面清洁剂或欧利雷科加强型清洁剂进行清洁。让表面干燥。
使用前摇匀即可。
a）大面积的全面修复：按照10-20克/平方米（50-100平方米/ 升）保养木油用量进行涂抹，或使用喷雾器均匀喷涂。允许短停留时间（最多10分钟），然后用手或抛光机在白色衬垫上进行抛光。
b）较小表面的部分修复：用木质护理油（约10-20克/平方米）浸泡白垫，在表面上涂抹。最多10分钟后。用干棉布清除多余的油。
用前应使表面干燥至少12个小时,最好是在一夜之间。在头几天不要弄湿表面。

燃的危险！立即清洁被污染的衣服/垫，并投放在水里。

清洁、维护

DRY CLEANING: Daily cleaning of oiled / hard wax oil-treated floors should be carried out dry with a broom or vacuum cleaner, as sand and dust act like sandpaper and can cause fine scratches. Loose dust on furniture surfaces can be easily removed with a cloth.

WET CLEANING: For regular cleaning with water, the mild „OLI-NATURA wood soap“ is ideal. It is specifically designed for the needs of oiled / hard wax oil-treated hardwood floors, floorboards, wooden stairs and furniture surfaces, and ensures rapid cleanliness and restoration of oil without leaching or attacking the wood.

APPLICATION: Shake well before use! Pour OLI-NATURA wood soap at a ratio of 1:200 into lukewarm water, wipe surface and leave to dry. Finished! For stubborn stains, do not dilute before use. Wipe off with water afterwards. Mixture: 25 ml to 5 litres / 50 ml to 10 litres.

RESTORATIVE TREATMENT AND MAINTENANCE: From time to time the oiled or hard wax oil-treated wood should be given some restorative treatment and maintenance. This will renew the protective effect and buff out slight scratches. Previously hard wax oil-treated surfaces should be treated at regular intervals with „OLI-NATURA wood care wax“. Oiled wood, however, should be restored with „OLI-NATURA wood care oil“. The entire surface can be treated, but it is also possible to treat only specific areas. After such treatment, the wood is anti-static and thus attracts little dust.

APPLICATION: The surface must be totally clean, dry, and free from dust and grease before treatment.

1.1 Full-surface restorative treatment for parquet: Apply approximately 10-20 g/m² (50-100 m²/l) of OLI-NATURA wood care oil or wood care wax thinly and evenly with a mop or a sprayer; allow to take effect for a short time (max. 10 minutes) and polish in with a white pad by hand or with a polishing machine. 1.2. Partial restorative treatment for parquet: Soak a white pad with wood care oil or wood care wax (10-20 g / m²) and rub in. Remove any excess with a dry cotton cloth after a maximum of 10 minutes.

2.0. Restorative treatment for stairs: Soak a white pad with OLI-NATURA wood care oil or wood care wax (10-20 g / m²) and rub in. Remove any excess with a dry cotton cloth after a maximum of 10 minutes.

3.0. Restorative treatment for furniture: Pour OLI-NATURA wood care oil or wood care wax onto a clean, lint-free cotton cloth and apply evenly and thinly along the grain. Remove any excess with a dry cotton cloth after a maximum of 10 minutes.

Note: Let the impregnated surface dry for a minimum of 12 hours, preferably overnight. Do not wet wipe for the first few days. In the case of sensitive surfaces, test first on an inconspicuous area.

Important: Oil soaked cloths / pads may spontaneously combust due to heat accumulation. They should therefore be cleaned or soaked in water immediately after use.

了解更多